Liberty-pumps ALM-P1 Manuel d'utilisateur télécharger pdf

Supplemental Installation Manual

7247000C

MODEL

ALM-P1

Supplemental Installation Instructions for your ALM-P1 Alarm

Product Description

The ALM-P1 is an alarm system that utilizes a water sensor connected to an alarm panel to detect a high water

situation in a sump pump application. The sensor clamps on to 1-1/4” or 1-1/2” PVC pipe. When water bridges the

probes, the alarm box will activate an alarm light and horn. The horn can be silenced by switching the rocker switch on

the side. The alarm light will still function even when the horn is silenced.

Installation of the Water Sensor Probe on discharge pipe

1. The water sensor for the ALM-P1 was designed to be installed directly onto a pump discharge pipe. The clamp will

only fit onto 1-1/4” or 1-1/2” pipe. See figures 1 and 2.

2. Determine correct height for the water sensor. The alarm will turn on when the bottom of the probes detect water.

The correct height for these probes should be above the turn on point of the pump and well below the top of the

sump pit.

3. Connect wires from water sensor to the alarm panel. Red wire must be connected to the “left” terminal, labeled

R/W. The black wire must be connected to the “right” terminal, labeled B. Wire up to the panel can be secured to

the pipe with the included zip tie.

4. Test the pump and the turn on level of the alarm. When satisfied with the probe position, mark the level on the

discharge pipe. For added security, slide the probe clamp away from intended position and apply a small amount

of PVC glue to the discharge pipe. Return the alarm probe to desired position. The PVC glue will bond the pipe

and clamp to prevent accidental movement.

5. To test the water sensor, immerse both probes in water or place a wet rag or sponge across the probes. The

alarm panel should activate. Completely wipe and dry the probes before putting the unit back into service.

Probe level

1-1/4” or 1-1/2”

discharge

Figure 1

Figure 2

1-1/4” or 1-1/2”

discharge

Probe level

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - Product Description

Page 2 - For proper installation

Page 3 -

Page 4

Page 5 - Descripción del producto

Page 6

Page 7

Page 8

Page 9 - Description du produit

Page 10 - Pour que l'installation

Page 11

Page 12

Commentaires sur ces manuels

Pas de commentaire

Liberty-pumps ALM-P1 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Liberty-pumps ALM-P1. Liberty Pumps ALM-P1 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Liberty-pumps ALM-P1